If it were not for the few quality control issues and additional requirements for me to drill and fix small parts, I would have given this stand a five star review. At this price point, I am still saying this is a good product and I am happy about my purchase.I was skeptical based on the negative reviews; however, I was willing to risk it at the price point for a 2,000 lb capacity stand that was large enough for my new 125 gallon aquarium. Either upgrades have been made or the negative reviewers were not assembling the stand correctly.Once the bolts and screws are tightened, the unit is very stable and does not wobble as demonstrated in the negative video review. The only wood screws are for attaching the MDF/fiber board sides and attaching the power strip to these boards.There are also additional brackets that are installed that prevent sway side to side and front to back. Prior to installing these, there were no stability issues after fully tightening all the screws.Overall I am very satisfied with my purchase and I have not doubts about the ability of this stand to work for my aquarium. There are a few flaws or areas to improve that I have listed below.There were extra screws, bolts, and rolls of the anti-slip foam tape.The shelf supports screw into the legs instead of simply sliding in. This is a nice feature and makes the shelf very stable. The shelf itself has an external support beam that is mounted during assembly and has notches for the supports to slide into and stabilize the shelf.CONS: Limited quality control prior to shipping. The sides have the alignment holes mismatched. I had to drill a new pilot hole in the side to align with the metal side.The foam anti-slip tape comes up short on the long sides. The short middles are deliberately short to allow the longer front and back pieces to fit; however, these pieces were short a full side piece width to reach the end. I used the spare pieces to cut a small extension.Three holes were either not properly tapped/cut or misaligned. Two of them were only bad enough to need a little extra force to thread, then I backed out and used and new bolt/screw. One was so bad that I used force until the bolt stopped turning. Overall the stand is extremely stable and this one bolt did not cause any issues with stability.Not a negative thing, but I would personally have an alternate location for the power strip to mount and include an additional shelf. Since the power strip is mounted to the sides with screws, this can be done easily.If you need a heavy duty aquarium stand at a reasonable price, this is a great option.